How to Caulk a Large Gap Around a Bathroom Sink: One Simple Trick
The caulking around our bathroom sink really needed replacing, and on some sides there was a big gap, about 3/8 inch, between the sink and the wall. As a DIY guy trying to do the best job, I ran into some difficulties. Here’s what happened, the tools and materials I found helpful, and how I ultimately got a well-sealed sink that has held up for over six months.
I’m not a professional, and it wasn’t a perfect job by any means. This is just my experience, so follow at your own risk.
Before You Begin: Fill the Gap First
The only way to seal a gap that big is a big, fat bead of caulk. To stop it from sinking down into the gap, I first pushed a door seal strip in below the surface as a backer. That’s the trick that made the difference.
Tools & Materials I Used
- Caulk removal tools (I tried two, plus a plastic scraper and a putty knife)
- Baking soda for cleaning
- Rubbing alcohol and a cloth
- A self-adhesive door seal strip I already had, as a gap filler
- Silicone caulk and a caulking gun
- Soft caulking-gun tips from a tool kit (I used the 13 radius)
- A razor blade for cleanup
Step 1: Remove the Old Caulk
I tried two removal tools. One flexed too much and I wasn’t impressed. Even after sharpening the end of the other with a file, it wasn’t easy. A plastic scraper worked beautifully until it broke, and in the end a putty knife worked best.
Step 2: Clean Everything
Preparation gives you a big advantage. A couple of teaspoons of baking soda really helps clean the sink and the wall tile, and gets the grease off. Then I wiped everything down with alcohol, because I could still feel a soapy film and I didn’t want the strip to come unstuck.
Step 3: Install the Gap Filler Strip
I peeled the backing from one side and stuck the strip against the wall, then pushed it down below the surface of the sink edge. Cut it a little long and trim it afterwards, since it’s hard to peel the tape once it’s cut short. On the side where the sink almost touches the wall, I didn’t bother, because the caulk fills that by itself. The strip expands to fill the gap where it’s wide.
Step 4: Prepare the Caulking Gun
My tube had been sitting for about a week since the last job. When I pulled the cap off, the caulk underneath still looked fresh. I tried one of the soft tips that came in the kit for the first time.
Step 5: Apply the Caulk
The tip makes a huge bead, and this caulk is very shiny and flows easily, which is great, but I ended up with a lot of extra in the corner and a bit of a mess. Don’t leave it sunken in. I remember the last caulk I used shrank as it dried, so a little extra is better.
Step 6: Correct the Mess
Working around the sink edge is the hard part. The caulk sticks as you try to pull away, and when I let go of the gun, the tip spun around on its own. These soft tips bend a lot. I filled in what I could and used a smaller bead in the corner.
Step 7: Clean Up
I cleaned up the excess with a razor blade, carefully, and then alcohol on a cloth to remove the leftover silicone. Tip: don’t do this kind of job late at night, when you don’t have quite the same faculties.
Final Thoughts: Six Months Later
It’s not perfect, but six months later everything is sealed very well and no water is going down the edge like it was before. From a distance nobody notices. For a cleaner result on a tub, see how I recaulked my bathtub.