How to Set Up the Isinwheel M40 Folding E-Bike (Car Trunk Test)

This is my first folding e-bike, the Isinwheel M40 with 26-inch wheels. At the time, it was the least expensive 26″ folding bike, and the big question for me was whether it would fit in my car trunk without hanging a bike rack on the back of the car. Here’s how I unboxed it, assembled it, folded it, tried it in the trunk, plus my pros and a few cons.

This is my own experience with my bike. Read the manual, double-check every bolt before riding, and follow at your own risk.

What I Wanted to Know

  • How easy is it to assemble?
  • How easy is it to fold?
  • Is it difficult to carry folded?
  • Does it fit in the car trunk?
  • Is it easy to carry up and down steps?
  • Do I need the basket?
  • How fun is it to ride, and how good are the shocks and brakes?
  • What’s that big box on the frame?

Tools Used

Disclosure: Some of the links below are affiliate links. As an Amazon Associate, I earn from qualifying purchases. If you choose to buy through them, it helps support my work at no additional cost to you.

  • Isinwheel M40 26″ folding electric bike https://amzn.to/4m1zNhL
  • The included toolkit (with the 15 mm wrench for the pedals and a key with a screwdriver on the end)
  • A bungee cord to hold the folded bike together (not included)

Step 1: Unbox and Charge the Battery

In the box there’s the saddle, pedals, a small toolkit, reflectors, the power supply, the user manual and the basket with the battery. A few nuts and bolts had fallen loose into the box. The chain and most of the bike come assembled, so you just add the saddle, handlebars, pedals and front wheel.

Charge the battery first. That big box on the frame is the battery. It needs the included key to unlock, and the charging port is right on it. Mine showed a red light while charging.

Step 2: Install the Handlebars and Light

I ended up taking out all four clamp bolts so the clamp could go over the top, then set the bars with the brake levers in the right position and lined up the little target symbol in the middle. Then I mounted the front light.

Step 3: Install the Pedals

The pedals screw directly into the cranks. They’re marked L and R with the tightening direction. Screw them in by hand, then tighten with the 15 mm wrench from the toolkit. I could feel a locking thread as it tightened.

Step 4: Install the Front Wheel

A tip I got from another YouTuber: flip the bike over and rest it on the handlebars and seat. It’s much easier to handle the wheel that way. Make sure the disc rotor is on the same side as the caliper, drop the axle into the fork so the rotor slots between the brake pads, and close the quick release with a good amount of tension.

Step 5: Fold It and Load the Trunk

Position the pedal so it’s out of the way and put the kickstand up. Then release the frame latch, pull up on it and the bike folds. At about 60 pounds it’s a little awkward. A bungee cord holds the two halves together. Carrying it up steps is possible if they’re wide, but I wouldn’t want to do it every day.

For the trunk, I loosened the handlebar stem with the included key so the bars could go on top. It went in, with some room left over. That was the whole point of buying this bike, and it works.

Step 6: Unfold and Get Ready to Ride

Take off the bungee, lift the spring-loaded section until the pin locks down, close the latch and make sure it’s tight. Then reset the handlebar with the key, eyeball it straight and tighten it. Set the seat height, but don’t pull the seat post above the minimum-insertion mark.

Verdict: Pros and Cons

  • Assembly: not that difficult.
  • Folding: not hard. You just have to deal with the weight.
  • Car trunk: it fits, which is the big plus for me.
  • Basket: it holds the battery and is useful for carrying a few things.
  • Riding: fun, it got me back into riding, and the extra power helps on hills.
  • Shocks: good, with an adjustable rear shock and front suspension.
  • Cons: no quick release on the stem and seat (you need the key), a fairly short wheelbase, and the seat height is a little short for me. that’s a very simple fix with a part that costs less than $10 (see my e-bike seat height upgrade).

If you want to fold it every day, this may not be the best bike for that. But if you just want to take it around in the trunk sometimes, it’s a good, fun bike.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *