How to Swap in a New Hisense Window AC the Simple Way (Vinyl Window)

In this video I take out my old window air conditioner and install a new Hisense 12,000 BTU unit, which the seller provided to me for this review. My windows are double-hung vinyl, so I’ll show how I install it without resting all that weight on the thin sill.

Read and follow the safety instructions in your manual. This is for information and educational purposes only, so follow at your own risk. The manual recommends two people for this, and with a unit this size, that’s a very good suggestion.

Before You Begin: Support the Sill

Don’t let the AC sit on that thin vinyl strip. I use a piece of wood as a shim underneath so the weight is spread out instead of resting on the narrow sill.

Tools You’ll Need

  • The new AC with its side curtains (“wings”), insulation strip and bracket packet
  • A piece of wood to support the unit on the sill
  • A leftover board to brace the window, plus a saw to cut it (I used a small Japanese saw)
  • Optional: screws, double-sided tape or duct tape
  • A grounded outlet

Step 1: Remove the Old Air Conditioner

Unplug it and remove whatever is securing the window. I had a piece of wood and a shim. The weight wants to tip the unit out the window, so pull down on the inside as you lift the sash, and watch your fingers.

Step 2: Fit the Side Curtains

Most window units have similar side pieces. They’re marked left and right, and the T-shaped end slides into the track on the unit. Stretch them out to fit, and do both sides. Don’t put one on upside down like I did the first time.

Step 3: Set the Unit in the Window

Lift the window a little and set the AC on the wood support, holding on to it the whole time so it can’t fall out. Make sure it sits behind the sill lip, then bring the window down onto the top of the unit. The fit on this Hisense was very good with only a little adjustment needed.

Step 4: Seal and Secure It

They include some insulation you can put along the top before closing the window. The instructions recommend screwing the side panels in, and there are brackets to stop the window from opening. I prefer not to use screws, so I cut a leftover floorboard to fit tight between the top of the sash and the frame. If you’re worried, you can add duct tape or double-sided tape.

Step 5: Power It On

Make sure you plug into a grounded outlet, because the case is metal. This unit has on/off, modes for fan, dry, cool and eco, low/medium/high fan speeds, and Wi-Fi, which I’ll cover in another video. On high I measured about 65 decibels and about 63 on low.

Final Thoughts

AC’s in, nothing fell out the window, and I still have all my fingers, so I’m calling that a win. If you’re worried about your vinyl windows holding the weight of an AC, a simple wood support makes a big difference.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *