How to Dig a Footing for a Sagging Beam: Is 18 Inches Deep Enough?
To support the sagging beam in my crawl space, I needed a pier with a proper footing under it. My first plan was a hole 2 feet square and 3 feet deep, until I realized some of the advice I’d been given (including from AI) didn’t account for the fact that this is an enclosed space.
Please treat this video as entertainment, not advice. The best way to decide on footing depth is to check with your local building department and make sure your project meets local code. Follow at your own risk.
Before You Begin: Check the Depth With Your Local Code
Don’t rely on AI, other people’s videos, or even mine for the depth. While I was taking a break from digging, I watched other videos where people dug shallower holes, and one pointed out that you don’t need to worry about the frost line inside an enclosed building. Checking that saved me a lot of unnecessary digging and extra bags of concrete. I settled on about 18 inches, which is a bit more than necessary but should make a very solid footing.
Tools You’ll Need
- Laser level
- Paint stick or marker
- A chisel to break through the concrete floor
- A small shovel (handy in a tight crawl space)
- Somewhere to put the dirt
Step 1: Find the Center of the Beam
I marked the center of the beam and transferred that mark down to the floor with a laser, making sure the laser was parallel to the wall.
Step 2: Mark a 2-Foot Square
Using a paint stick, I marked a 2 foot by 2 foot square on the concrete where I wanted to dig, centered on that mark.
Step 3: Break Through the Concrete and Gravel
Before I could dig, I had to chisel away the concrete. Under that was a layer of gravel to remove, and only then could I get to the earth underneath.
Step 4: Dig to Depth
There were a few rocks, but it wasn’t too bad. At 15 inches it was going better than I expected, and the final depth was about 18 inches. Plan ahead for where the dirt will go, because it adds up quickly.
Final Thoughts
I don’t do this for a living, so it was a tough job, but checking the depth requirement before going to 3 feet saved a lot of work. In the next video I set the rebar and pour the footing, and then I install the jack post to support the beam.