Crawl Space Inspection After 30 Years: How to Check for Damp and Sag
For 30 years I ignored the crawl space under the addition at the back of my house, until a damp smell finally forced me to look. It could have been mold or even sewer gas. I also want to put new flooring in above it, so I needed to know that what I’m building on is sound.
This is the first video in my crawl space rehab series. I clear out the debris, pull out badly installed insulation, check moisture levels and find a beam that’s sagging. I’m a homeowner, not a contractor, and I’m learning as I go, so follow at your own risk and protect your lungs.
Before You Begin: Protect Yourself
Wear a proper respirator. I used a silicone full-face mask with a single canister. It gets hot, but a damp, smelly crawl space full of old insulation and debris is not somewhere to breathe freely.
Tools Used
Disclosure: Some of the links below are affiliate links. As an Amazon Associate, I earn from qualifying purchases. If you choose to buy through them, it helps support my work at no additional cost to you.
These links may not be the exact items I used, due to availability.
- Full-face respirator mask https://amzn.to/4wOnElX
- Digital moisture meter https://amzn.to/4flM92U
- Laser level https://amzn.to/3Rfjswu
Step 1: Clean Out the Crawl Space
A lot of what was down there was old cardboard and carpet, and those carry a smell. Even while I was in there, the place definitely felt damp. Getting everything out is the first step to seeing what you’re dealing with.
Step 2: Remove the Upside-Down Insulation
The insulation had been installed upside down, with the vapor barrier facing the wrong way. It’s supposed to be up against the floor. I took all of it out so I could inspect the structure.
Step 3: Take Moisture Readings
With the insulation out, I used a moisture meter on all four corners and the middle. There are different wood types, so I set the meter to the type that shows the highest reading and used that as a reference. The first corner read 13.3%. I found a cracked spot that’s open to the outside, higher readings near the joint where the addition meets the house, and a high reading on the beam itself.
Step 4: Check the Beam for Sag With a Laser Level
I set up a laser level along the bottom of the beam. The walls looked straight, but toward the middle the beam is sagging about an inch, and it has a visible bow. Checking just above the mortar line all the way around, the foundation was actually not bad for a hundred-year-old house.
What’s Next
The plan includes sealing up vents, building a pier and footing, raising the sagging beam safely, insulating the exterior walls with a termite gap, leveling and sealing the floor, and looking at a possible French drain and dehumidifier options. You can follow the next steps in digging the footing, pouring it and installing the jack post.
Final Thoughts
Honestly, I’m not excited about this job, but it has to be done. If your house smells bad above a crawl space, I hope this real footage shows you how to start inspecting it.