How to Replace a Plastic Water Heater Drain Valve in One Easy Swap
The drain valve on my gas water heater was the original plastic one, and people say those aren’t reliable in the long run and can fail. I swapped it for a solid brass boiler drain valve for durability, leak prevention and better flow when draining the tank, and I did it without emptying the tank.
There is an element of risk here. If the old valve breaks off while the tank is full, you’re in big trouble. This is my experience on my heater. Follow at your own risk, and call a plumber if you’re unsure.
Before You Begin: Let the Water Cool
I turned the gas control to the pilot position and used up the hot water, then left it for several hours so the burner wasn’t firing. When I let a little water out, it was just warm. That’s how you want it.
Tools & Materials Used
Disclosure: Some of the links below are affiliate links. As an Amazon Associate, I earn from qualifying purchases. If you choose to buy through them, it helps support my work at no additional cost to you.
- 3/4 in. brass boiler drain valve https://amzn.to/4o35Y1p
- Teflon tape
- A container to catch water
- A wrench or pliers
- A knife to slit the plastic cover
Step 1: Turn Off the Water Supply
Shut off the cold water supply so there’s no pressure on the tank.
Step 2: Relieve the Pressure
I saw another guy use the pressure relief valve for this, so I opened it to let the pressure out and some water drain away, then closed it again. If the valve sticks, that’s another problem, so be ready.
Step 3: Tape the New Valve
Wrap the threads of the new brass valve with a few turns of Teflon tape so it’s ready to go in quickly.
Step 4: Swap the Valve Fast
The theory is that with the supply off, unscrewing the drain creates a vacuum at the top of the tank, which holds the water back long enough to get the new valve in. My plastic valve wasn’t on very tight, and I could almost take it off by hand. With a container ready, I unscrewed it, quickly threaded the brass valve in, closed it, and gave it another turn to tighten it.
Step 5: Turn the Water Back On and Check for Leaks
I left the plastic cover off at first so I could see behind the valve, then turned the water back on. There were no leaks at the new valve or at the pressure relief valve. I slit the cover so it could go back over the new valve.
Step 6: Turn the Gas Back On
Turn the gas control back on from pilot and listen for the burner to fire up, so nobody complains about having no hot water in the morning.
Final Thoughts
The original plastic valve is basically a plastic pipe that doesn’t let much water out very fast. The brass one should let more of the sludge out when I flush the tank. It’s a simple, inexpensive fix, as long as the old valve isn’t stuck tight. When it’s time to flush the tank, here’s how I drain a water heater tank. And while you’re at it, don’t forget the sacrificial anode rods.
One Comment