How to Replace a Kohler Toilet Fill Valve the Easy Way (GP1138930)
Water was still flowing into my Kohler toilet long after it had been flushed. That’s an indication that the fill valve is leaking constantly, and that’s going to cost money on the water bill eventually. Knowing how to change a toilet fill valve can save you having to pay for a plumber, and it’s really quite easy.
I’m not a plumber, and this is simply how I did it on my toilet. Follow the instructions that come with your valve, follow at your own risk, and use proper safety precautions.
Before You Begin: Get the Genuine Part
If you have a Kohler toilet, get genuine Kohler parts to be sure the valve is right for your toilet. I used the Kohler GP1138930 Silent Fill valve kit, which is the valve designed for this particular toilet and has the correct flow rate. It comes in a gray body and a black body version. Mine was the gray body, so that’s what I matched.
Tools & Parts Used
Disclosure: Some of the links below are affiliate links. As an Amazon Associate, I earn from qualifying purchases. If you choose to buy through them, it helps support my work at no additional cost to you.
- Kohler Genuine Parts fill valve, gray body https://amzn.to/3ImdzFO
- Kohler Genuine Parts fill valve, black body https://amzn.to/3UYcCuE
- Fluidmaster universal toilet fill valve (if you don’t have a Kohler) https://amzn.to/49CFgpG
- Siphon for emptying the tank (works with gasoline and oil too) https://amzn.to/430dFMy
- A sponge or a cup for the last of the water
Step 1: Shut Off the Water and Empty the Tank
Turn off the water at the shutoff valve. Then flush and hold the handle down to get as much water out as possible that way. I was lucky to have a siphon that a neighbor gave me, but you can get the water out whichever way you can, with a cup or a sponge. Once the siphon couldn’t pick up any more, I soaked up the rest with a sponge.
The whole point is that you don’t want water coming out of the bottom of the tank when you take the valve out.
Step 2: Disconnect the Supply and Remove the Old Valve
Disconnect the supply hose under the tank. There’s going to be a little bit of water coming out, but not much. Undo the locking nut under the tank, and the old valve lifts straight out.
Step 3: Set Up the New Valve Like the Old One
Compare the new valve with the old one. The new one had a white cap where the old one had a blue one, but the gray body is what counts. My old valve had a green orifice, which controls the rate of flow, so I used the green one from the little packet that comes with the kit.
The old valve was taller, so I adjusted the new one up to a similar height before putting it in.
Step 4: Install the New Valve
Put the new valve in place and fit the nut underneath. The kit has a new washer, and it also came with a new hose, which I fitted too.
Step 5: Reconnect, Turn On the Water and Test
Reconnect the supply underneath and tighten it, then turn the water back on. I turned it on full and kept an eye out for anything leaking while the tank filled. Then flush it and check that the fill stops the way it should.
Final Thoughts
Interestingly, the float on this genuine Kohler valve says Fluidmaster, so I guess they have them made by Fluidmaster. But when you get it from Kohler, at least you know you’re getting the part that is designed for your toilet. It’s a quick job that stops a running toilet from wasting water.