How to Fix a Dead 20V Power Tool Battery With a Car Charger

I received this 20V aftermarket battery, which fits the Craftsman line of 20V tools, through Amazon’s Vine program to review, and it arrived completely dead: zero volts, no lights, no response. I left it on the standard power tool charger for hours and nothing happened. If you’ve bought a battery online that arrived dead, or you’ve left one sitting too long, this might be the fix you need.

Important safety note: lithium-ion batteries can be dangerous. I’ve had a pack set on fire after a short circuit, so I did this outside to reduce the fire risk. This is something you should never do at home unless you’re willing to take the risk. It’s for educational purposes only. Proceed at your own risk!

Why the Charger Wouldn’t Work

The pack was measuring only about one-point-something volts. Some chargers need a minimum voltage before they’ll recognize a battery, and I think this one was just too low for the regular charger to kick in.

Tools Used

  • Torx bit to open the pack (four screws)
  • Car battery charger
  • Voltmeter
  • The standard power tool charger

Step 1: Open the Pack and Check the Connections

Four Torx screws hold the case together. I opened it to look for loose connectors or broken wires, and everything looked solid. Inside there are ten cells and a circuit board.

Step 2: Jump-Start the Cells With a Car Charger

I disconnected the circuit board and connected the car battery charger to the cells. The charger has three modes. The first showed an error, but in another mode it said “charge” at 12.8 volts. After about five minutes it read “full”, and my voltmeter showed 13.76 volts.

Step 3: Reassemble the Battery

I reconnected the circuit board and pushed it back in firmly, then put back the button, the clamp and its spring. It wasn’t difficult to take apart or put back together. Just don’t forget the screws (I did, once).

Step 4: Charge It on the Regular Charger

This time the original charger recognized it and started charging, and the fuel gauge lights came on. After an hour or two it was up to 19 volts, which is a whole lot better than zero, and it powered my drill. I also discovered the light on the pack comes on with a long press of the button.

Final Thoughts

A deeply discharged pack may just need a nudge above the charger’s minimum voltage. This method may also work for batteries that have sat unused and lost their charge over time. But please respect the fire risk and do it outside, away from anything that can burn.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *