How to Use a Stainless Steel Cable Tie Gun: The Easy Way to Make It Tight

I picked up a Dafonso kit that comes with a stainless steel cable tie gun and a bag of stainless steel straps. I wanted to show how it works and how clean the cut is.

This is just how I used it on my own project. Follow the instructions that come with your kit, follow at your own risk, and wear gloves, because the cut ends of steel ties can be sharp.

Before You Begin

The kit says the ties will go around a pipe up to about three and a half inches. In practice you need some extra length sticking out so the jaws inside the gun can grab it, so I’d say you can really hold on to something closer to three inches.

Tools You’ll Need

Disclosure: Some of the links below are affiliate links. As an Amazon Associate, I earn from qualifying purchases. If you choose to buy through them, it helps support my work at no additional cost to you.

Step 1: Understand How the Gun Pulls

Feed the tail of the tie into the nose of the gun. When you squeeze the handle, hardened steel jaws grab the tie and pull it up. Let go of the handle and the tie is free again, so keep hold of it between squeezes. Keep squeezing until the tie has as much tension as you want.

Step 2: Cut It Off

On the other side there’s a spring-loaded lever. It turns a cylinder with a slot through the middle, and that rotation shears the tie. Pull the lever and it cuts very easily, leaving a neat finished end.

Step 3: Try It on a Real Job

My test was on some rusted poles that are part of a frame. I had wrapped them with tape before. I put the tie around, threaded it through, then pulled the poles together until it was snug. Because this is very light-duty tubing, I didn’t crank it as hard as I could. I just held it at the tension I wanted and turned the lever, and it snapped off cleanly. Then I did another one the same way.

Wrap-Up

This little tool makes stainless steel ties quick to fit. The only thing to watch is that the tie goes slack again when you release the handle, so hold on to it while you work. On my poles the ties came out nice and tight, and they should be good for another couple of years.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *