How to Replace the Battery in an APC Back-UPS 600 the Easy Way
I’ve had this APC Back-UPS 600 uninterruptible power supply for 14 years. The other day it started showing a red light when it was plugged in, so after that long I figured the battery was no good.
This is how I replaced it on my unit. Turn the UPS off and unplug it first, follow at your own risk, and recycle the old battery properly.
Before You Begin: Choosing the Battery
After 14 years, the original APC battery has a pretty good track record, so if you want to be sure, get the APC replacement. I went with a Mighty Max because it’s a lot cheaper, and I already have one on a small generator that has started fine even after three months sitting.
Mighty Max makes 7, 8 and 9 amp-hour versions for this UPS. The difference was about five dollars each, so I got the 9 Ah, which should run longer if the power goes out. The size listings on Amazon can be confusing, so check the dimensions. Mine fit nicely.
Tools You’ll Need
Disclosure: Some of the links below are affiliate links. As an Amazon Associate, I earn from qualifying purchases. If you choose to buy through them, it helps support my work at no additional cost to you.
- APC RBC17 replacement battery (for BE650G1, BN600 and others) https://amzn.to/3CusjD3
- ML9-12, 12V 9Ah F2 terminal SLA AGM battery https://amzn.to/4aBMZWp
- Mighty Max 12V 7Ah F2 replacement battery for APC Back-UPS 600 BN600 https://amzn.to/4aDD8zg
Step 1: Turn It Off and Unplug It
Switch the UPS off and unplug it. (I unplugged mine first, then remembered to turn it off.)
Step 2: Open the Battery Compartment
It’s very simple. Pull the battery door open and tip the unit up so the battery can slide out.
Step 3: Disconnect the Old Battery
Pull the battery over far enough to reach the terminals and pull the wires off. On mine the black wire was on top and the red on the bottom. The original battery is idiot-proof, because the terminals are shaped so you can’t put the black wire on the positive.
Step 4: Connect the New Battery
Here’s the one thing to be careful about: on a non-original battery you could put the wires on the wrong terminals. Connect red to the red (+) terminal and black to the black (−) terminal. Then slide the battery in and close the cover.
Step 5: Plug In and Test
Turn it back over, plug it in and switch it on to check that it works.
Wrap-Up
That’s how you change the battery in an APC Back-UPS 600, and it should be very similar on the 650 and other close models. If this new battery lasts anything like 14 years, I’ll be very happy.