How to Sharpen Battery Lawn Mower Blades the Easy Way
My battery-powered mower has been in use for a few years and the blades needed sharpening. Sharp blades make mowing easier and quicker, and they cut cleaner.
I was also sent a small bench-top belt sander for free to review, so I wanted to see if it was any good for this job. This is how I did it on my mower. Follow your mower’s manual, follow at your own risk, and wear gloves around the blades.
Before You Begin
Take the batteries out first. Make sure the mower can’t start while your hands are near the blades. A nice thing about a battery mower is that you don’t have to worry about gas leaking when you tip it over.
My mower has two motors, and the blades spin in opposite directions. That means one blade has a left-hand thread and the other a normal right-hand thread. There’s a directional arrow on each blade that shows which way it spins.
Tools You’ll Need
- A wrench or socket for the blade bolts
- A piece of scrap wood to stop the blade turning
- A file
- A small belt sander (optional) and a 600 grit belt for finishing
Step 1: Remove the Blades
Wedge a piece of scrap wood in to stop the blade from turning. The blade spinning tightens its own bolt, so you loosen each one against its direction of rotation. On my mower the first one came off the opposite way to normal (left-hand thread), and the second came off the conventional way. Neither was very tight.
Each blade sits on a half-moon shaped fitting. It turns out you can flip a blade over so it cuts in the other direction, and that’s how they use the same blade on both sides.
Step 2: Check the Damage
Mine were just plain dull, and one had a big chunk taken out of the edge. Honestly, the best thing would be new blades, but I wanted to see how far I could get sharpening them.
Step 3: Try the Belt Sander
The sander came with belts from 120 grit, the coarsest, up to 1000. It has a spring-loaded pulley to tension the belt, a speed switch, and forward and reverse. I ran it on the lowest speed with the belt moving away from me so the sparks went the other way.
The problem is there’s nowhere to rest the blade, so you have to hold it at the right angle by hand, and it was hard to keep it consistent.
Step 4: Use a File Instead
For these badly damaged edges a file was easier and more accurate. I could hold it at just about the right angle and see exactly what was happening. I got both blades as close as I wanted with the file.
Step 5: Hone the Edge
With the sander unplugged, I put on what looked like a 600 grit belt (the belts have several numbers on them). Then I used it just to hone the edges, this time running toward me, to help the edge last a little longer.
Step 6: Put the Blades Back
Each blade sits on its platform, and the left-hand thread goes back on its own side. Make sure the blade seats down far enough to engage before you tighten it. Snug is enough, because the spinning will tend to hold it tight. Then put the battery back in and test it.
Wrap-Up
A file did most of the work here, and the little sander was fine for a final hone but not heavy enough for real reshaping. Just remember the opposite threads when you take the blades off and put them back on.