2-Prong to 3-Prong Adapters: The Hidden Danger Inside One
Only have a 2-prong outlet? No problem, just get one of those 2-prong to 3-prong adapters, right? Before you order one of those clean-looking adapter boards, read this. I received one free from a seller on Amazon in exchange for a review, decided to test it, and then opened it up to see what’s going on inside. I gave it the lowest possible rating.
Electricity can kill. I only opened this adapter while it was unplugged. If you’re not sure about your wiring, talk to a licensed electrician.
Why the Third Prong and the Polarity Matter
The round third prong on a 3-prong plug is the ground, and your device may need it, especially if it has a metal case. In the United States, the narrower blade is the hot wire and the wider one is the neutral. Polarity matters because a switch on a device should switch the hot wire. If it switches the neutral, the device can still have power in it when it’s off.
Older outlets and extension cords with different-size slots only let the plug go in one way. This adapter has two narrow prongs, so it can go into the wall either way round.
Test 1: The Polarity Flips When You Turn It Around
I used a tester to find the hot wire. Plugged in one way, the hot was on the correct side. When I turned the adapter around, the polarity at the board was reversed too. There’s nothing inside that makes sure the narrow slot is always the hot. There’s also a red and a green light on it, with no label to tell you what they mean.
Test 2: What’s Inside
With the adapter unplugged, I took the cover off. The incoming wires go to the switch, and there are a few electronics just to light the LEDs. There’s no surge protection that I could find. Most importantly, the ground bus that your 3-prong plug connects to is connected to absolutely nothing, except the other outlets on the board. The ground pin isn’t a ground at all.
Safer Solutions
- If it’s your property, the best solution is to replace old 2-prong outlets with modern 3-prong outlets.
- If you can’t, be aware that a device with one wide prong is designed that way to keep the hot wire on the right pin, and a 3-prong plug’s ground is a safety feature. This kind of adapter can reverse the polarity and takes away the ground in both cases.
- Many devices, like phone chargers, only need a 2-prong plug, so you may not need something that just looks like it has a ground.
- If you must buy one, choose a better-quality unit with a certification such as UL or CSA (whatever applies where you live), ideally with real surge protection.
Final Thoughts
This board is a potential shock and fire hazard. If something looks too cheap, there’s probably a reason for it. Use these with caution, and hopefully this keeps someone from a big problem. You can find more of my honest gear reviews in my DIY Gear Reviews playlist.