Torn Speaker Cone Repair: The Best Cheap and Easy Way I Found
A year ago I set out to restore an old Harmony 420 tube amp, and I found that the speaker, a vintage 15″ Jensen Special Design, had a torn cone around the outer edge. It still worked, but buying a new speaker or getting it re-coned can be expensive. I had nothing to lose trying to repair it myself, and the results were beyond what I expected. It works like new.
This is my experience on one speaker, not a professional re-cone. Follow at your own risk, and if you have a valuable vintage speaker, consider getting expert advice first.
Materials Used
- CA glue (super glue) and activator
- Wood glue, diluted with a little water (I used a craft glue that came with a little brush, but any wood glue should work)
- Single-ply toilet paper (I used Scott)
- Leftover spray paint and masking
- Gorilla Glue, a piece of plywood and clamps (for re-gluing the cone edge to the frame)
Step 1: “Tack Weld” the Tear With CA Glue
If you’ve ever done any welding, you might know tack welding: you fasten certain sections first and then weld between them. I did the same thing here, pulling the torn parts back together and spot gluing them with CA glue and activator. It didn’t go perfectly the first time, so I did a bigger area and let it soak in. The goal is to get the cone back into the shape it’s supposed to be.
Step 2: The “Chamly Method” of Paper Strips
Next comes the part I’m claiming as the Chamly method. To get paper to follow the curved profile of the speaker, hold a single sheet of toilet paper down along the edge with your finger and tear it as you go, in strips about 3/4 inch wide. Torn this way, it fits the curve surprisingly well.
Step 3: Paste the Paper With Diluted Wood Glue
I thinned the wood glue with water, brushed it on the cone, laid the paper on top and dabbed more glue over it. It got into place very easily. I worked my way around the edge one piece at a time until the whole tear was covered. You can pick off any little loose bits afterwards.
Step 4: Mask and Paint
The glued repair looked a little ugly, so I masked off the area and sprayed it with some leftover paint. It actually looks pretty good.
Step 5: Re-Glue the Cone Edge to the Frame
After testing the speaker in the amp, I found that part of the cone edge had separated from the metal frame. I glued it with Gorilla Glue and clamped it down with a piece of plywood. Be careful the glue doesn’t expand onto the plywood and stick it to the speaker.
Final Thoughts
For the cost of some glue and toilet paper, this speaker is back in service and works like new. If you have a vintage amp, loudspeaker or hi-fi with a torn cone, it’s worth a try before you spend money on a replacement. There’s a longer 30-minute version with more details on my GuitarBasement channel.