Fix Chair Wobble for Good: The Easy String-and-Glue Trick
If your wooden chair keeps coming loose no matter how many times you tighten the screws, the hole has probably become too big for the screw to bite. One of mine was so worn out that I had to try something different. Instead of replacing the chair or drilling it out, I wrapped the screw threads with string and glued it back into the wood.
It took a few days of waiting for glue, but the result is rock solid. This is my own repair, so follow at your own risk.
Before You Begin: Try Tightening First
First, just try tightening the screw. If it’s been done a few times and the screw spins in the hole, that’s when this trick comes in.
Tools You’ll Need
- A strand of string or cord
- Glue to hold the string on the screw (I used shoe glue; CA glue might be better)
- Wood glue
- Small vise grips to hold the screw while you wrap it
- Clamps (I used Jorgensen Cabinet Master clamps)
- A screwdriver (I used a Craftsman ratchet screwdriver)
Step 1: Wrap the Screw Threads
Put a little glue on the screw to hold the start of the string, then wrap the string around the threads and cut it off. Small vise grips are handy for holding the screw. Add a few drops of glue at both ends so the string stays in place, and let it set overnight.
Step 2: Add Wood Glue to the Hole
The next day, put a little wood glue into the hole. The wrapped screw is a lot fatter than it was, but it should still go into the hole.
Step 3: Clamp the Joint and Drive the Screw
To give it the best chance, clamp the joint tight, then drive the screw. I prefer a regular screwdriver here so I can feel it. Mine didn’t spin in the hole at all and I could put a good amount of force on it.
Step 4: Clean Up and Let It Cure
Wipe off any squeeze-out and leave it overnight again. I did both sides of the chair.
Final Thoughts
The chair is rock solid now and feels better than new. This works for loose dining chairs, wobbly wooden stools, stripped screw holes in wood and furniture that loosens over time.