Vinyl Floor Cutter for Thick Laminate: The Easy Way to Make Clean Cuts
I’ve laid several DIY floating floors using Pergo laminate, and every time I only used the tools I already had. Nothing specialized. I could have saved time, made cleaner cuts, and avoided being pelted with hard chips from a circular saw.
So I got a 13″ vinyl flooring cutter to see if it would handle thicker laminate. This is my experience with it. Follow the manufacturer’s instructions, follow at your own risk, and keep your fingers well away from the blade.
Before You Begin: What’s in the Box
The box lists a lot of materials it’s meant for: PVC, LVT (luxury vinyl tile), luxury vinyl plank, VCT, vinyl floor and plank, rubber flooring, foam tiles, laminate floors, engineered floor and siding. Inside I found the cutter, a handle, a sharpening stone, a manual, an Allen key and some measuring stickers.
Tools You’ll Need
Disclosure: Some of the links below are affiliate links. As an Amazon Associate, I earn from qualifying purchases. If you choose to buy through them, it helps support my work at no additional cost to you.
- 13″ Pro Manistol SPC, LVP, LVT, WPC and rigid core vinyl flooring cutter NLVT-330 https://amzn.to/3H7EMyL
- The Allen key that comes in the box
- A scrap piece of your flooring for test cuts
Step 1: Fit the Handle
Back out the screw with the Allen key so the handle can go in. Mine was a tight fit with a few burrs, so I backed the screw out again until the hole lined up and the screw went through.
Step 2: Set the Guide
There’s a guide bar to put your piece up against. You can set it along the edge for a square cut, or move it to the marked lines and pivot holes for angled cuts. I didn’t check the instructions for exactly what each line is, but one setting is clearly 45 degrees. The new holes were a bit snug the first time.
Step 3: Make a Straight Cut
I used a test piece of laminate left over from a small flooring job, with a rough edge on it. I came down on the handle expecting a bit of noise and effort, and it went straight through. That was quite impressive.
Step 4: Try a 45 Degree Cut
With the guide set to 45 degrees, it cut just as cleanly. That’s a heck of a lot easier and nicer than trying to do it with a circular saw.
How the Blade Works
The top blade has a sharp angle on it, but there’s also a blade underneath that I didn’t notice at first. When you bring the handle down, the top blade passes very close over the bottom one, less than a millimeter, so it cuts from the top and the bottom at the same time.
For carrying, you bring the blade down and lock it with a little catch, which holds the handle in place. I wish that catch didn’t stick out quite so far, but that’s how it’s designed.
Wrap-Up
This flooring cutter surprised me. It makes clean straight and angled cuts in thick laminate without the flying chips you get from a circular saw, and I’ll be using it on my next flooring project.