How to Restore an Old Exterior Door the Cheap Way: Bondo and Paint

During the summer I took on the project of fixing up an old wooden exterior door, and the goal was to do it as inexpensively as possible with not much more than sandpaper, some Bondo and some exterior paint. I fixed the rot and made it look more respectable, and it now has a finish to keep the weather out for years to come.

Wear a dust mask and eye protection when sanding, and follow the directions on your filler and paint. This is how I did my door. Follow at your own risk.

Before You Begin: Plan for a Day Without a Door

Once you start a project like this, you have to get the door back on, or you don’t have a door on your house. Have everything ready before you take it down.

Tools & Materials Used

  • Belt sander and hand sander
  • Sandpaper: 40, 80, 120, 180 and 240 grit
  • CA glue and hardener (activator) spray
  • Bondo body filler and hardener
  • Clamps and a block of wood
  • Good quality exterior paint
  • An inexpensive electric spray gun
  • A new kick plate for the bottom

Step 1: Take the Door Apart and Remove the Glass

Take the door down, remove the hardware, and take out the glass so you can work on the wood.

Step 2: Sand Off the Old Finish

I used a belt sander and a hand sander to remove the old paint and prepare the wood for a new finish.

Step 3: Fix Damage With CA Glue

Where there was serious damage, I got CA glue in as far as I could, then clamped it down. Put something between the clamp block and the glue so you don’t stick the wood to the block. With hardener spray it sets fast.

Step 4: Fill Holes and the Door Bottom With Bondo

Fill the holes and rough spots with Bondo. In hot weather it goes hard pretty quickly, so work fast.

Step 5: Side 2, the Bad Side

The kick plate on the other side was almost falling off, and behind it there was more damage than I’d expected: rotten wood at the bottom. If it hadn’t been repairable, the best thing would have been a new door skin. I took off a whole layer of the plywood because it was so bad. Getting that surface off took me hours.

Then I stiffened the bottom edge with CA glue and hardener, and did the middle section too, to make the whole bottom edge nice and rigid. Two layers of Bondo, with a light sanding between them, rebuilt the edge.

Step 6: Finish Sanding

I sanded down at 40 grit, then went through 80, 120 and 180. I didn’t get too fussy at the bottom, because a new kick plate covers it up.

Step 7: Spray Paint

I sprayed with the door on its side so I could hold the gun vertical. I rigged up a stand with a clamp and a block of wood, plus a piece of wood with a couple of nails to hold the door at the doorknob hole.

Test the gun on scrap first. My first test was very blotchy, and it turned out I had assembled the gun incorrectly. I also dampened the wood to raise the fibers before the first coat, then went over it with 240 grit once it dried.

Spray gun tip: the air cap directs jets of air, and its orientation sets the spray pattern. Turned one way it sprays wide horizontally, the other way vertically. It was the opposite of what I thought, and I learned by experience.

Step 8: Reassemble and Reinstall

I was too busy getting the door ready to film all the final stages, but it got reassembled and the door went back on. I painted the inside and the outside the same color, and put a new plate on the bottom.

Final Thoughts

With sanding, CA glue, Bondo and decent exterior paint from a cheap electric spray gun, this old door looks a lot more respectable and is sealed against the weather. Before replacing a rotten door, see if a little Bondo can save it.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *