How to Fix Exhaust Pipe Holes Yourself: The Best Way I Found

Holes in an exhaust pipe are a common issue. Here’s how I repaired mine using Walker 35958 exhaust paste and thin stainless steel strips. Things didn’t go perfectly. It got messy, but I stayed determined and got the job done, and you can learn from my mistakes so you can avoid them on your project.

Make sure the exhaust is cold and the vehicle is safely supported before you get underneath. This is my experience on my SUV. Follow at your own risk.

Tools & Materials Used

  • Walker 35958 muffler putty (exhaust paste/cement)
  • A thin stainless steel strip (mine was left over from a bigger sheet; you just need tin snips to cut it)
  • Stainless steel cable ties
  • Some soft wire (my plan B)
  • Vise grips
  • An old sanding belt
  • Shears or wire cutters
  • A heat gun
  • A jack (on an SUV I could reach in from the rear without lifting it much)

Step 1: Clean Up Around the Hole

I went over the area with an old belt from a belt sander. My biggest concern was that the pipe had become pretty thin around the hole.

Step 2: Paste and Wrap the Stainless Strip

Since the cable ties are pretty big, I put a couple loosely around the pipe first so they were ready to slide over the steel. Then I put paste around the hole, wrapped the stainless strip around the pipe (it wraps more than once), and added more paste to seal everywhere. The paste stuck surprisingly well. The strip even stayed in place when I let go.

Step 3: Tighten It Down (Plan B: Wire)

Mistake #1: I tightened the cable ties with pliers and vise grips, but they wouldn’t close the strip up as much as I wanted. So I switched to some wire I had kept. You can twist wire tight with the vise grips, and it held better than the ties.

Mistake #2: don’t overtighten. Twisting stretches the wire right at the twist, which becomes the weakest point, and I snapped one. Once you know how much it can take, make it nice and snug and stop. Then cut off the excess and add a little more paste around the fasteners to keep everything together.

Step 4: Find and Patch the Other Pinholes

Putting the camera in there let me see things I couldn’t see from where my eyes were, and I found another couple of pinholes. I used some thicker pieces of steel I had, plastered paste around the holes, and held the steel on with wire and vise grips. The tricky part is that once the paste is on, you can’t see exactly where the hole is.

Lesson learned: I stopped wasting time with cable ties. They’re meant to tie cables, not exhausts.

Step 5: Cure the Paste

The paste says to let it dry, but in cold weather that takes a long time. I gave it some encouragement with a heat gun on the high setting, and later ran the engine for a while to help it harden.

Final Thoughts

The exhaust pipe is sealed and we’re back in action. It might not have gone perfectly, but the job got done, and I hope this gives you the confidence to do it yourself. If you’re not sure where your leaks are, I also have a video where I use a smoke test machine to find exhaust leaks.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *