How to Replace a Mazda CX-9 Blower Motor: The Hard Part Nobody Tells You

Our 2011 Mazda CX-9 still had the original 13-year-old blower fan, and it was taking a long time to come up to speed. I had a tough time getting the old one out. It wasn’t terrible, but it’s important to know what to expect before you start.

The replacement fan from Amazon arrived a day after I ordered it. It has balance weights on it, which tells me they made some effort to balance it, and it runs quietly and gives a powerful blast of air. This is my experience on our car. Follow at your own risk.

Tools & Parts Used

Disclosure: Some of the links below are affiliate links. As an Amazon Associate, I earn from qualifying purchases. If you choose to buy through them, it helps support my work at no additional cost to you.

  • HVAC heater blower motor with wheel fan cage, fits 2007-2015 Mazda CX-9, replaces TD11-61-B10 700289 https://amzn.to/3R8qaRE
  • Torx T25 bit (I realized afterwards a hex socket fits these screws too)
  • A screwdriver
  • Vise grips

Step 1: Remove the Glove Box

To get better access to the blower motor, take the glove box out. Squeeze the sides to release the retaining tabs, and it just comes out.

Step 2: Remove the Bottom Panel

The panel under the dash snaps in place. Pull it and it comes straight down.

Step 3: Undo the Three Screws

Underneath the blower motor there are three screws. I used a T25 Torx bit. Once they’re loose, the motor is ready to come down.

Step 4: Disconnect the Wiring (the Hard Part)

This is what nobody warned me about. The connector has a tab you press in, and the wire is supposed to just come out easily. It didn’t budge. Mine did drop down by itself, which gave me better access, and in the end I put vise grips on the connector and pulled it while pushing the release in at the same time. It was like pulling a tooth, so take your time and be ready for a fight.

Step 5: Install the New Blower Motor

After that struggle, putting the new one in was a piece of cake. Make sure the wires are out of the way, line the motor up so its outlet faces the side where the air goes, push it straight up and put the three screws back in. Plug in the connector, then snap the bottom panel and glove box back in.

Step 6: Test It

Start the engine and test the fan. Oh yeah, you can hear that. Beautiful.

Final Thoughts

If your CX-9 fan is slow to spin up, the blower motor is a very doable DIY job. The only real challenge is that stubborn electrical connector, so now you know what to expect.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *