CNC Course (13) Arc Entry & Full Circles in One Line

🎥 Video

📝 Overview

This lesson shows a cleaner way to start and finish a circular cut instead of plunging straight into a counter-bore, the tool enters on a gentle G3 arc lead-in and leaves on an arc lead-out. That reduces tool deflection, reduces the little corner cusp that can form where a cut starts, and leaves a smoother finish on the wall of the bore.

It also covers how to program a full 360° circle in one line using an I-offset to define the circle’s center, even though the start point and end point are the same. That’s the case the R method from the last lesson can’t handle reliably due to ambiguity. The video finishes with a dry run of a 40 mm bore with a smooth entry and exit.

📌 What You’ll Learn

  • How to use a G3 arc entry to avoid tool marks
  • Why arc lead-ins and lead-outs produce cleaner counterbores
  • Using R-values for simple arcs
  • Using I-offsets to define the circle center
  • How to program a full circle in incremental mode (G91)
  • A step-by-step walkthrough of the toolpath and code
  • A live demonstration cutting a 40 mm bore

📂 Tools & Software Used

  • 3018-style CNC router
  • Candle (GRBL Control)
  • GRBL firmware

📘 Description

Watch this useful technique for smooth circular cuts using arc lead-ins and lead-outs with G2/G3. See how to enter a counter-bore using a gentle arc instead of plunging straight in, reducing tool deflection, eliminating corner cusps, and producing a cleaner finish. You’ll also see how to program a full 360° circle using I-offset center coordinates, even when the start and end point are the same.

💡 Key Takeaways

  • An arc lead-in lets the cutter load up gradually instead of all at once, so the wall of the bore stays clean.
  • R-values are fine for simple arcs, but they can’t describe a full circle where the start and end points match.
  • I (and J) give the center of the arc as an offset from the start point, which makes a one-line full circle possible.
  • Programming the circle in G91 keeps the code short and easy to reuse.

🔗 Related Lessons

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *